Since its formation, Beran’s aim has been quality, service and innovation. The Beran On-Site Services Team has added another important element - flexibility.
We know that outage plans are complex and subject to change, which is why we remain as flexible as possible to suit your needs. If you need us on a different date, give us a call! - we will do our best to accommodate your requirements.
Vibration Transducer Calibration – Whether on-site or return-to-base, we can cover all your calibration needs.
Transducers are tested to the manufacturer’s specification, over a range of 5Hz to 5kHz. You will have UKAS-traceable results for an Amplitude Step and Frequency Step test profile; we will also carry out a Frequency Sweep, in order to ensure that there are no 'peaks' or 'troughs' between the standard UKAS frequency points. All points are phase tested and measured, which is important for balancing the machine. This gives you greater confidence in the signals on which your Condition Monitoring Equipment is reliant - remember, “garbage in” equals “garbage out”.
Open Loop Signal Injection - After a transducer has been calibrated, we can also shake the device at a number of pre- determined vibration levels, whilst it is connected to your Turbine Supervisory Equipment and any other monitoring equipment.
Signal checks can then be undertaken at all equipment locations to ensure the following:
Beran System Health Check - This is the most thorough check available for your Beran PlantProtech™ Condition Monitoring System and associated equipment, and consists of a full system calibration with the following additions:
(* = where installed)
For all customers with the full Beran Maintenance Support Package, any failures identified during the System Health Procedure will be repaired on the same visit, where possible, saving you time!
Additional Equipment / Software – The Beran Off-Site Services Team are happy to deal with any additional requirements you may have, as we have the relevant knowledge and experience to fit hardware or software upgrades into your existing system. The upgrade will be seamlessly linked into your current Condition Monitoring System.
